Addons for Transformers Earthrise Quintesson Allicon 3D print model

So this one pretty much came out of a request to add back those spikey and decidedly unsafe horns to Allicon's head in alt mode, which were very possibly left out due to child safety concerns. So here's our shot on recreating those and getting the Allicon the spear which was also seen in the 86' movie!

The horn attachment prints as a single piece and can be painted to color match after printing. The spear comes in 4 different parts, the tip, the top portion, the shaft and the spikey ball on the bottom.

The shaft being a separate piece allows for it to be re-sized to whatever length you prefer, and all the parts need to be separate so the staff can be slid into Allicon's hand and then assembled as a whole.

Transformed into his bot mode, the spear can be held in rather the same fashion.

As for the horns attachment, they can be left on top of the head with the tail folded loosely over it, or simply fully removed.

Alrighty then, hope everyone has fun printing a bunch of these for your Allicons too, especially so if you are army building with them too! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog