Sableye - Halloween - POKÉMON FIGURINE - 3D PRINT MODEL

This is "Sableye" from Pokémon Halloween series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Sableye is a bipedal Pokémon with a dark purple body, armed with sharp teeth and claws, which it uses to dig through soil. It has pale blue, gemstone-like eyes, which allow it to see in low light and sparkle in the dark. It also has a red gemstone on its chest, and its back has a blue and green gemstone as well as another red one. These gem-like eyes and adornments on its body are caused by its diet, which consists of rocks and raw gemstones. It also targets Carbink as prey, though they are usually taken by Gabite before Sableye can reach them. It is feared by people since it is said to steal a person's soul if they look into its eyes. It is nocturnal and is rarely seen. It lives in caves.

As Mega Sableye, all the energy from its Mega Evolution is concentrated into the red jewel on its chest, causing it to rip out of Sableye's skin and significantly increase in size; the detached jewel leaves a small hole in Mega Sableye's chest. Its ears elongate, and it gains a spike on the top of its head. Its teeth turn from white to yellow, and its eyes also change from pale blue to a crimson red, with diagonal slits at their inner edges. Its back gains more gems: a second green one, a second red one, and two small yellow gems. The enlarged jewel is said to boast such incredible hardness that no attack can even leave a scratch on it. During battle, Mega Sableye shelters itself behind the jewel, from where it can take advantage of any openings its target leaves exposed.[1] However, being forced to support its massive jewel leaves Sableye unable to turn quickly, making it vulnerable from behind.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.