Pumpkin Party Hookah

Just in time for Halloween!

With these models you can turn a real pumpkin into a fun party hookah! Print as many hosebase and mouthpieces that you need.

*Please note!
You will need 3/8th Outer Diameter plastic tubing for the "hoses" (normally found at any DIY building materials store such as Lowes, Menards, or Home Depot. and a 14mm glass slide bowl that normally come with bongs.

whats included?
*the mouthpiece that attaches to one end of the 3/8ths tube.
*the hosebase/retaining nut that attaches the hose to pumpkin
*the stem assembly which holds the 14.mm bowl
*the Base and Assembly punches to make perfect holes in pumpkin.

Print all pieces, cut a lid on the pumpkin, clear out all the insides.
punch hole in lid for the stem assembly and fill with water so that the holes in the stem are submerged. fill with water/ice.

use the basepunch (marked B) on the sides below the lid for as many hoses you desire, I made mine 3 feet in length and insert hosebase from the outside, screw on retaining bolt.

replace lid and you are ready to rock!
*you may have to either press down slightly on the lid when hitting this hookah depending on how clean your cut for the lid is. alternatively I got tired of doing this and sealed the lid with hot glue along the cut.

Enjoy and Happy Halloween!!

Layer height of .02
supports are not needed for the basepunch, however I recommend using them for all other files. print position as your slicer opens is optimal.