Footrest for Triton and Nortik Folding Kayak

I designed this Footrest for my Triton Viktor (same as Nortik Argo) and did a 500km Holiday Trip with it. It worked very well.
The Picture inside the Boat shows this first Version. The current Version is as shown on the Picture with the two sets. The new version gives you about 50mm more space between the footrests, so its easier to fit items thru.

Tested on Triton Viktor, Nortik Argo, Triton Ladoga

I always Printed it in PETG with about 25% infill, Support ON i usually use Treesupport in Cura, including Support makes about 270g per part

1. Print Scale Rings to Scale the Model to your Printer Print Settings as in the later Print but with a Raft ( to avoid Elefantsfoot) To have the Part really fitting tightly to your 20mm tubes of the Frame you have to scale it. Because no printer is really capable to achieve the right hole diameter.
2. Try the Scale Rings on your Frame Tube. Choose a good fit.
3. Scale the Footrest Model with the Number on the best fitting Scale Ring.
4. Mark the Area to not Support (like on the Picture) If you dont do this you cant get the support material out. The two Holes are connected in a Loop so you can put a Cable Tie on if you like. (i haven't used it on the photo from the inside of the Kayak)
5. Print
6. Repeat Steep 3-5 for the other Side