Filament Holder FALCON59

Once a time. I didn't know where to put my spool, so...

As you can see in the photo, you need to print 2 shafts, four wheels.

Bearings:
1. The size of the bearings in the design is Inside D. 10, Outside D. 30, Width 9, all in millimeters.
2. I am using the cheapest bearings I can find, but it will not roll smoothly, because of the grease inside. So to get it sleek, you need to ply open the plastic cover(so buy the one that has plastic covers, not metal), brush them off, then apply a tiny bit of bicycle oil(not grease).
3. Don't buy nylon bearings in the photos, that is only for presentation.

Attaching it to the floor:
To prevent it from moving around in the process of printing, there are two ways of fixing it to the floor.
1. Using rubber pads in the picture, glue them under the wings and tail(recommended).
2. Using screws. There are two screw holes in the chest and tail. they are both in 3mm diameter.

Chamber:
I designed a small chamber and a cover. The chamber is designed to store screws that might be used in the future. You can see a Chinese character “延” inside, it is the first character of the name of the city I am living in, “延吉”。

Designed in Fusion 360.

I am a 3d printing enthusiast living in China, if you have anything to make or reverse-engineer, contact me, let's have fun together :).

https://www.facebook.com/MeariSori
https://www.instagram.com/mearisori/
WeChat: wino2014

FDM is enough to get useful stuff.