Optional walls for the Great wall boardgame by Awaken Realms
Optional walls for the Great wall boardgame by Awaken Realms
3D
Published 2022-01-22T10:59:21+00:00
Optional Walls for the Awaken Realms game The Great Wall. These were designed with the following goals in mind.
1. Each section can fit the “floor” card from the original walls if you would like to play with them.
2. When stacked they are approximately the same height as the original walls when stacked. They are actually slightly shorter if used without the floor cards and slightly taller if used with the floor cards.
3. They can all nest within each other for ease of storage.
4. When nested they are the same height as the original walls when nested.
5. The large wall sections can fit next to each other in the box perfectly
Since they are intended to fit the top floor cards of the original wall they end up being a little wider than the originals but this has not proven to be an issue when playing the game with them.
We’ve included 3 sets of files. The first has the floor and perimeter of the walls separated out to make it easy to print them flat with no supports. The second has the floor and perimeter joined. The third has supports added for printing in a resin printer. Note that these supports will need to be cleaned up a bit in post if going that route.
These were designed by Solomon Steadman using assets from the Easefare defense wall pack https://www.myminifactory.com/object/3d-print-195039.
We have released them to the community for free.
Towers for the Black Powder expansion will be released in about one months time.
| Date published | 22/01/2022 |
| Support Free | YES |