Custom Nomad Nose Cone

This is a 3D model of the nose cone for the Nomad kit manufactured by the Custom Rocket Company. The stock nose cone fits a BT-60 outer tube with a BT-50 inner tube.

There are nine models from which you can download and print.
1) Stock nose cone without shoulder.
2) Stock nose cone with shoulder that fits BT-50 airframe tubing.
3) Stock nose cone that is hollow without shoulder. (It will print support inside depending on your slicer settings.)
4) Stock nose cone that is hollow with shoulder that fits BT-50 airframe tubing. (It will print support inside depending on your slicer settings.)
5) Stock nose cone that is solid without shoulder. (You can select the amount of infill inside the nose cone.)
6) Stock nose cone that is solid with shoulder that fits BT-50 airframe tubing. (You can select the amount of infill inside the nose cone.)
7) End cap with a 1.5mm hole that will allow for screw eye or eye bolt.
8) Upscale to 4 inch diameter (OD: 101.6mm, ID: 99.06mm) for Aerotech airframe tubing with a shoulder that fits 2.6 inch (OD: 66.93mm, ID: 64.97mm) Aerotech tubing for the inner tube. The nose cone is solid so you can vary the infill for it and has the shoulder attached.
9) Four inch endcap has a 3mm diameter hold for placement of a screw eye or eyebolt.

I'd like to thank Randy M. for helping me with getting the dimensions and close up photos of this nose cone from the kit he owns.

This blog did a build of the kit.
http://modelrocketbuilding.blogspot.com/search/label/Nomad

Custom Rocket Company website.
http://www.customrocketcompany.com/

-