Mi Band 5 wrist band
Mi Band 5 wrist band
Published 2021-08-29T18:47:29+00:00
Just a simple alternative to the classic xiomi mi band bracelet.
This will not break after a couple of months as the original...
INSTRUCTIONS
Part1 is the main piece. It is open at one end to allow some deformation to insert the whatch.
Part2 is the chain. These pices are held together using small 1.75 filament pieces.
Part4-5 is the open-close bit
If you like it you could use some M2 bolts to hold the various pieces together instead of filament pieces.
PRINTING
I used my resin printer but this should be printable on any FDM machine with a small nozzle (0.4mm or smaller).
If needed you can drill out the holes to get a better fit.
Hope you like it!! If so please leave a like
Edit 26/08/2021: Designed a simple latch to open and close the chain easily. (Part 4 and Part5)
Date published | 29/08/2021 |
Support Free | YES |
Thanks for sharing!!! Layer: 0.12mm Infill 50% With Supports I printed de first piece face down