Inverted Pentagram Tumbler

This is a tumbler holder that its design is shown off by printing it in 2 colors.

It has a low relief to contain the drops of perspiration from the glass (in case it is cold), or for small spills.

To print it in such a way, you will have to follow the following steps:

1) Print the base of the cup holder "Star David Base" and leave it adhered to the printing bed.

Place the "Star David Base" on the printing bed in the following axes: X=0 Y=0 Z=0

2) Change the filament to a contrasting color.

3) Print the inverted "Star David" pentagram.

Place "Star David" on the printing bed on the following axes: X=0 Y=17.5 Z=0

NOTE: The inverted staff file "Star David" has a small block, which is used to reach

the exact height on which it should be printed on top of the base.

VERY IMPORTANT!!!

You must activate in CURA, an option called "Z-jump on retraction" and "Z-jump height".

and set a value of "1 mm". The latter will make the extruder go up 1mm when performing retractions,

which will serve to avoid collisions with the wall when printing the inverted staff.

of the previously printed base.

And this is how you manage to have at the same layer height, different colors.

Upload a photo of the print of this design and tag me!

I hope you like this design and enjoy printing it!

I welcome ideas for printing with this method if you have any in mind ;)

Layer height: 0.2

Wall thickness: 1.5

Material temp: 210 (PLA from Print to Lot)

Bedding temp: 60

Flow rate: 100%

Velocity: 55

Displacement: Enable retraction and "Combing Mode"-> "All".

Enable "Z-jump on retraction".

Z-skip height: 1 mm

Supports: NO