Unicron Trilogy - MASTER KEY - EARTH

THIS is the EARTH inspired master key, i tried to be as faithful to the design as possible, i included 2 variants, one with the minicon post in the middle of the key and one with the logo, both have the same gimmicks the only difference is the placement of those 2 details

note: the colored images are form the key without details i already made, it helps to understand what gimmicks it is compatible with, description below

Update: printed thanks to the same friend that printed the non-detailed version
printed using a 100micron resolution printer, so details dont look as crisp as they should, anyway, thanks to camarada prime for the help

original description:
i decided to make a piece that will be able to activate all 3 main gimmicks of the transformers cybertron trilogy(armada - minicons, energon - stars, cybertron - cyber planet keys)
but with some tweaks i managed to add some extra gimmicks to the piece

yellow colored parts represent the minicon compatible 5mm posts, which have a hole in the middle colored orange and ports
which have a pin also colored orange

these allow the key to activate minicon gimmicks or hold a minicon on them

on the inside one can see a green section shaped so it can be plugged onto 5mm posts that lack the hole in the middle

the minicon post on top allows for cybertron figures without minicon compatible posts to be able to have one (plugged onto the key itself

with the amount of 5mm posts and ports it can also be used or be held by other compatible figures(dotm, wfc trilogy, chug, to name a few)

blue represent the sections that go around the energon star section on energon toys, if able, use a semi translucent filament to complete the look, the minicon post and ports will make it difficult to see the spark crystal though

last but not least, red represents the section that fits on cyber planet key ports, these are an exact replica of the piece, although the body of the key is way smaller

this version lacks any specific detail though (minicon post detail, cyber key body or symbols, any faction logo, or energon star shape) i will try to make all designs, although the cyber key logos (velocitron, earth, and others) will be placed on the hexagonal piece instead of the middle of the key, might or might not release version with faction symbols depending on legality of doing so

the key is ready to be print, but just to be clear, remember, even if this uses precise measures, it hasn't been tested yet

ust orient it so the flattest part goes to the bottom
standard automatic supports should work, but just in case, i would set them up to the minimum thickness so they can be easily removed, the piece is not that big so the thicker they are the more difficult is to reach them given the shape
PLA is recommender over abs

details can be as small as 0.3 mm, a 50 microns printer can be configured to print them, but it varies from printer to printer, so, check your settings before printing, a printer with 70 to 100 microns might not be able to print them though