Witchstone organizers

Organizers for Witchstone board game. All organizers fit the game box very well and provide quick game setup. Containers with useful lids + theme ornaments.

All one player's components are arranged in one container. There are 4 sections for: 1. hex tiles, 2. small witch figures, 3. energy units, 4. wizard figure + animal marker + owl counters + crystals. All sections have rounded bottom to facilitate item draw. The container can be covered with a lid. The lid is inserted along short guides in the container. There's an indentation in one side of the container that facilitates ejecting the lid.
There are 4 ornamented lids. Each one has a relief of a different wizard with an animal. Ornaments are related to the pictures in the board game.

3 types of tokens are accommodated in the token organizer. It is a container with a lid. 3 sections are provided for: 1. magic chips, 2. owl tiles, 3. special hex tiles. All sections have rounded bottom to facilitate item draw. The lid is ornamented with owls.

A simple card tray is also in this set. It prevents the deck from scatter during the play. The sloped bottom with indentation facilitate card draw. (It is designed for cards without sleeves).

Version 2 - Card tray with a lid: I have also designed a card tray with a lid, that protects the deck during the storage. This tray is wider than the default simple one; so there's a dedicated Token organizer V.2 - a little shorter than the default one. This way they both fit the game box very well. Card tray with the lid and Shorter Token organizer with the lid are packed in Witchstone2_JKa.zip.

Some photos in higher resolution:
The set
Game set up
Green wizard with the toad
Blue wizard with the raven
Red wizard with the cat
Yellow wizard with the rat
Player components in organizers
Token organizer
Lid insertion solution
Version 2: The set, open organizers
Version 2: The set, closed organizers
Version 2: Unpacking

All organizers were 3Dprinted on Prusa MK3:
- in PLA (F3D gold pearl),
- No support is needed,
- Infill rectilinear:
- 10% - containers and tray
- 20% - lids
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: Special settings for lids to increase reliefs quality:
- first layer height = 0.15 mm
- 1 vertical perimeter
- Monotonic Top fill
- 20% Infill

Printing Time (for one organizer of each kind):
7h33' - player's components container (x4)
~3h50' - lid with a wizard relief (each one x1)
5h16' - token container (x1)
2h14' - lid with owls relief (x1)
1h57' - card tray (x1)

Version2:
2h - Cards, container
1h13' - Cards, lid
5h15' - Tokens, container (shorter)
2h10' - Tokens, lid (shorter)