Folding Paisho Board and tiles (from Avatar:The Last Air Bender)

This is a folding Paisho board, featuring a print-in-place hinge on the board, built in storage for the tiles, and a magnetic latch. Paisho is a board game featured frequently in Avatar:The Last Airbender, that has had many real sets of rules created for it over the years, most of which can be found here. The tiles included in the download can be used to play either Skud Paisho or Vagabond Paisho, some other versions may work but I am unsure.

The designs for the tiles were based on those from the garden gate, and the tiles can be downloaded separately here

Board
There are five files included for the board in the download, and the following quantities and colors of each should be printed:
-Board - 2 in yellow or a wood-like color
-Tip1 - 2 in red
-Tip2 -2 in red
-Tip3 - 2 in red
-Tringle - 2 in red, 2 in white
All parts print fine without supports and are to be glued together after printing. I used a cheap 5 minute epoxy from the dollar store and it holds up great. The red and white tiles may need some post prossessing to fit well onto the board if your prints suffer from a bit of an elephants foot like mine do.
As for the print orientation, the file for the board is in the closed position and should be printed vertically with the hinge on the bed so that the hinge prints properly. All of the red and white tiles for the board are to be printed flat.
For the magnetic latch I used these magnets from amazon. The cavity for the magnet fits a 30mm diameter, 3mm height magnet, so anything around that size should work, but I would test it before glueing the board together, as the magnets are no longer accessable once the board is assembled. If you require a different size for the magnet cavity just send me a message and I'll see if I can re-size it for you.

Tiles
There are 12 different tiles included in the download. For each of mine I printed the base in one color and swapped the filament to print the top in a different color. For base colors I did one whole set with black,and one whole set in yellow. For the top, the following colors should be used for the following tiles:
-Rose - red
-chrysanthemum - red
-Rhododendron - red
-Jasmine -- white
-Lily - white
-White Jade - white
-Rock - white
-Wheel - white
-Knotweed - white
-Boat - red then white
-Orchid - red then white
-White Lotus - red then white
I printed mine with 0.12 layer height and the top 4 layers are the image on the tile. For the last 3 in the list, 2 color swaps are required, with 2 layers of each color. This may differ for you depending on your print settings, but just check in the slicer before you print to be sure. The quantity of each tile for one players set of tiles is as follows:
-Rose - 3
-chrysanthemum - 3
-Rhododendron - 3
-Jasmine -- 3
-Lily - 3
-White Jade - 3
-Rock - 2
-Wheel - 2
-Knotweed - 2
-Boat - 2
-Orchid - 1
-White Lotus - 1