Food Chute for PetSafe Smart Feed Automatic Pet Feeder

Single food chute for the PetSafe Smart Feed Automatic Pet Feeder. I was using the original splitter version of this with two chutes, and that works great for two bowls of food. Unfortunately we are now down to one cat, so I remixed the original model to have only one chute.

You can go without any chute when using only one bowl, but the food tends to go all over and make a mess. This helps direct the food into the bowl and keeps the feeder area clean. Food no longer spills on the floor.

Assembly is the same as the original Food Splitter model. Insert the main part into the base, and then position the lip of the base under the feeder.

Print Settings

Printer: AnkerMake M5

Filament: PLA+

Infill: 20% Gyroid

Perimeters: 5

Solid Layers: 5 top, 4 bottom

Supports: I used organic supports only on one small bridge. Attached a picture to show where.

Layer Height: 0.2mm

Modified the original model to have only one food chute instead of two. Also added a little more tolerance on the slot of the base to make it easier to fit the pieces together.