Genshin Impact - Dragonspine Spear

This model is designed in two parts, the spearhead, and the pommel. Each part is then cut into pieces for easier printing and fit in a printer with a platform size of 200mm x 200mm x 200mm.

The spearhead is cut into 5 parts with each part sliced into half resulting in 10 pieces while the pommel is cut into 3 parts with each part sliced into half resulting in 6 pieces.

There is a picture with all the pieces labeled to their file names in the preview section which you can refer to.

All the pieces come with a flat face that can lay on the printing bed easily.

An uncut version of the spearhead and pommel is included as well just in case you need it.

Tunnels with a diameter of 10mm are punched on both the head and pommel for alignment and bone installation purposes. You can use anything with a similar diameter for these purposes. Just in case you can't find any, you can print the included "peg" file which is a cylinder with a diameter of 9.5mm.

Once printed pieces a and b, glue back to back using superglue or other suitable adhesives to form a part. Repeat the same for the other pairs and join all the parts afterward.

To bridge the spearhead and pommel, you can use the included "pole" file which is a cylinder of 180mm in length, with a diameter of 25mm, punched with a 10mm tunnel. You can use your own pole if you have a similar-dimension pole for this purpose.

For scaling, please use the same scale factor for all the pieces.

Cheers and Happy Printing!