iFlight Chimera7 Pro V2 Dragon Edition Guards and Bumpers

**Work in Progress** Tested**
         *Updated - May.25.23
         *Made For iFlight Chimera7 Pro V2.
           Can fit other 7-7.5 inch models, Verify yourself**

• Prop Guards V6.4 - I added MT30 Connector Holders with 2 Zip Ties slopes.
• Prop Guards V6.3 - I added Reinforcement on the Motor "Bowl" and on the Arms.
• Battery Holder V5.3 - I fixed a few glitches on the Head and on the wire clip.
• Front Bumper V3.1 - I added some spikes on the Bumper for the aesthetic.
• GPS+ELRS Tail V2-V2.1 - I edited the ring and Tail Spikes to fit the ELRS antenna better.
• Battery Holder V5.2 - I edited the horns tips to be more printable.
• Battery Holder V4.2 - I edited the bumpers to look better and be a little lighter.
• Battery Holder V4 - I Rebuilt the Bumpers.
• Lens Cover v2 - Fixed the top and clips.
• Front Bumper V3 - I Rebuilt the The Bumper to be lighter yet stiffer.
• Prop Guards V6 - Fixed many glitches on the guards and on some of the holes.
• Prop Guards V6  - Added more supports that adds 9 grams on each prop guards.
• Prop Guards V5 - I rebuilt the Prop Guards From Scratch.
• Prop Guards V4 - Reduced Prop Guard Weight and made it stiffer.
• Prop Guards V4 - Fixed the Honeycomb Wall hook to fit the Front Bumper hole better.

**Print Settings and details used on my prints For my Elegoo Neptune 3 Pro on Ultimaker Cura:

• PETG at Layer 1 to 4 (Pause at Height *Post Processing Setting* at layer 4) Change 
  filament (Rest of the print in TPU 95A)
• Flow at 105%
• Bed 90dgrs at first Layer then leave it at 80dgrs
• Nozzle (0.4mm) (height 0.2mm) at 240dgrs at first layer then 225dgrs
• Infill at 40% in Gyroid Pattern
• Retraction 3mm - slow (15mm/s)
• Speed 15mm/s at first layer then 30mm/s the rest of the print
• Added glue stick on bed before each prints
• No raft, brim or skirt.
• Support, needed for the Props guards Motor Section
• Motor ring on the prop guards was design for the Xing2 2809 (can fit smaller or equal)
• Front, Back Guards and The Feets Use Zigzag support pattern
• print the Feets with TPU only*

• Honeycomb wall Hook printed in PLA+ (205drgs - 100% flow - speed 60mm/s - Height 
 0.2mm)

•Shoulder Pads & Lens cover Printed in PETG (230dgrs - 100% flow - speed 50mm/s - 
 Height 0.2mm)

• No Dragon edition can be found Here >> https://www.printables.com/model/465552-7-75- 
 inch-fpv-drone-prop-guards-and-bumpers