Analog Tetris

UPDATED: Just added a simple stand to get the game rest vertically.

This is my first Model post so be gentle! I was hanging around with tinkercad and came out with this desktop puzzle Tetris game.

So I made a 10 slides bed for this game, and the footer that stops the Tetriminos at the bottom.

The Tetris slides bed I made was created with the possibility to join multiple beds to make it higher, you can print several beds and join them for a large tetris slide.

The footer is meant to be removed also so you can let the Tetrominos fall down and play again.

Printed with support in bed and footer only on Touching the build plate, just in case I printed all at slow rate.

I made all the Tetrominos to fit into the slide and they worked great at first attempt! Each one in a single file so you can print them in the amount and colors you want.

The game came quite big, you can reduce it and test. I printed my first model at 100% and is the one in the picture, needed to do some modifications to fit bed and footer correctly and after that printed at 50% as the one in the pictures as well. Bed and footer joins perfectly at 50%, the Tetrominos are quite small but worked well too. I think the better is 60% and higher.

Have fun and if so, consider leaving me a tip!