Sword model from Disneys The Sword in the Stone 3D print model

100% freehand model by me, this is my attempt at recreating the Sword from Disney's animated movie, The Sword in the Stone. Comes in 6 parts with the inscription on the blade just like the movie. Blade length is at 35 inches roughly and overall length is 45 in length. Printer settings I used on my CR-10 : bed temp at 55. Nozzel at 205. Print speed at 150mm/s, 3 walls and 10% infill. Feel free to alter the settings to your liking.

Recommended hardware: 1 half inch/ 13mm metal/wooden rod at 15 inches in length 2 quarter inch/ 6.5mm metal/wooden/fiberglass rods at 31inches in length

Pommel can be printed with hole end up with supports.

Guard can be printed with flat side down and supports underneath the 2 ends.

Let me know if you have any other questions or suggestions for other models!