Kobra MAX spool holder with LED

This is Spool holder with LED holder for ANYCUBIC KOBRA MAX
(LED light looks cool:))

You will need:
PARTS:

For: Spool holder (withOUT LED):
1. PVC tube (4cm)

For: Spool holder WITH LED:
1. 1,6x1,6cm triangular LED profile with cover (~53,5cm)
2. Wires (+) & (-) (~1,5m)
3. Switch (bipolar)
4. White LED Strips (~50cm): 24V (better) or two 12V serial connected (+|-|+|-)
5. PVC tube (4cm)

TOOLS:
Alien Keys
Wrench
Soldering Iron
Cutters for wires

Optional:
Glue (/hot glue)
Sanding paper
Knife

STEPS:
1. Print L and R
2. Unscrew 3 screws from each side (totally 6)
3. Take 3d printed part and screw it
4. Do the same step for the other side
5. Put the 4mm tube with filament spool into printed parts
(you can tilt printed parts a little)
^^^Done.^^^ Next steps for LED:
!!UNPLUG 110/230VAC CABLE!!

1. Solder wires to LED strip
2. Put LED profile into printed parts
3. Glue switch whereever you want
4. Solder switch
5. (then make a route for the wires) (((optionaly:) I drilled 2 holes- one on the top on right 3d printer profile and another one under right 3d printer profile))
6. Open bottom cover (unscrew 4 screws)
7. Connect + and - to free terminals of the 24V power supply
8. Close bottom cover with 4 screws ^^^Done.^^^ __________________________

If you have any questions- ask in the comment section :)
If you did my project, post a picture
If you like this, click "Like"
If you want to donate me: https://paypal.me/dawswa

(
Not important notes:
My project uses original screws (so you dont need to buy it)
Flat wall: 2mm high
Border wall: 10mm high
Triangular: 16,2x16,2mm hole
Circle: 40,2mm hole
)

♡