Gyver Lamp mounting base 3D print model

This is my vision for the mounting base version for the color chanfing very buteful Gyver lamp DIY set (for the Acrylic lampshade version). Are you ready to take your Gyver Lamp DIY project to the next level? Look no further! My meticulously designed 3D printed Mounted Base STL file is here to provide you with a seamless and professional solution that perfectly complements the Gyver Lamp DIY Set from AliExpress. My Mounted Base STL file is the result of hours of meticulous design and engineering, ensuring that it fits flawlessly with your Gyver Lamp components. Crafted with precision, it guarantees a secure and snug attachment, giving your DIY lamp a polished, professional appearance. This base was designed and fit 100% for the DIY set which was bought from this saler: https://www.aliexpress.com/item/4000384823406.html?spm=a2g0o.productlist.main.9.12b95748TMreUs&algo_pvid=b38ee32a-b0f6-46c0-b0a6-8157a53a137e&algo_exp_id=b38ee32a-b0f6-46c0-b0a68157a53a137e4&pdp_npi=4%40dis%21USD%2149.98%2123.99%21%21%2149.98%21%21%402103237316955156534624775e9541%2112000021860281713%21sea%21CA%21741920358%21&curPageLogUid=elwYHUEcB6cy

This model was printed in PETG, Layer 0.2, Infill 100%. Default printing orientation. No support needed. Before the assembling process, you will need to gently trim the power connector plastic shell about 2 mm (just to make the cover a bit shorter). After this procedure you will get the power connector to sit tight enough which provides its secure holding into the base. If you want to mount any legs on the bottom surface (I would recommend to do this for better cooling) there are 4 small holes at the bottom. I used a M3 screws which have 7mm diameter low profile cap. I put silicone caps on the screws head. I found the 1ml (smallest) medical syringe plunger silicone caps work very good for this usage. Of course you can also use any legs which can be glued by 2 side adhesive tape. The lampshade was mounted using a couple hot glue drops on the inside perimeter.