Lady Devil May Cry - Capcom Female Chracter

1-Base
2- Bazooka
3- Full Figure With Base
4-Ful Figure with bazooka
5-Full Figure and Base
6-Full Figure and Base With Bazooka
7-Head With Shoulder ( Sliced )
8-Torso and Lower All Body ( Sliced )

The model is loaded in 8 different types depending on your printing style. If you wish, you can print it in full form, or you can print it in parts. The model has been designed by examining all the details, and there are no cracks, holes or defects in it. If you encounter any problems with the model, contact me..

Follow me for more models
You can send me a message about the model or in general.
You can also reach me via social media.

Twitter : https://twitter.com/YunusKullebi
Instagram: https://www.instagram.com/yunuskullebi/

Print Temperature : : 200
Table Temperature : 60
Layer Height : 0.2 mm
Intıal Layer Heigt : 0.2 mm
Wall Line Count : 0.4 mm
Fill Density : % 20

Support Settings

Support Stracture : Tree
Maximum Branch Angle : 60
Branch Diameter : 3
Trunk Diameter : 16
Branch Diameter Angle : 5
Support Placement : Everywhere
Prefferred Branch Angle : 25
Diameter İncrase to Model : 1
Minimum Height to Model : 3
Intial Layer Diameter : 6
Branch Destinty : 20
Tip Diameter : 0.8
Limit Branch Reach : Yes
Optimal Branch Range : 30
Rest Preference : On Model if Required
Support Overhang Angle : 55
Support Pattern : Gyroid
Connect Support Lines : Yes
Support Density : 5
Support Line Distance : 8
Intial Layer Support Line Distance :8
Support interface Thicknes : 1.2