Buster Sword Dicesaber

Whether you're a First Class SOLDIER or a sword-for-hire, you can always rely on your trusty Buster Sword to win the fight. This special dice box can hold seven standard dice using the removeable dice tray. It comes with a magnetic sheath with slots for optional Materia orbs. The hilt is also available in either single-color bronze or two-color bronze and crimson finish. With this, you’ll be able to Omnislash your way to victory!

Files for the Buster Sword Dicesaber assembly includes a dice box, dice tray, sheath, and hilt. Most components are designed to incorporate magnets, although it is not required. The suggested default finishes should be silk silver, silk bronze, and crimson (for the dual-color hilt) as shown in the picture. All components are designed to be printed in PLA. It is advised to print the dice box and sheath upright on the printer.

Overall Dimensions:

Height (Bottom of hilt to top of sword): 12.25”
Width: 2"
Depth: 1.5"
Inner Chamber: 6.25" x 1" x 1"

Optional hardware
(1) M3 (5mm) square nut
(4) round 8x2mm magnets
(1) M3x18mm socket head hex screw

Sheath:
Lower portion of sheath has slots for round 8x2mm magnets (optional)
10% infill Rectilinear
0.2mm layer height (I have had success with 0.28mm with my Prusa Mk3s)
Brim suggested, 5mm width, inner and outer.
0.45mm widths
No supports necessary
Advised to print upright.

Hilt:
Multi-material optional
Slot for M3 square nut optional
10% infill Gyroid
0.2mm layer height (I have had success with 0.28mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.45mm widths
No supports necessary
Advised to print upright.

Dice Tray:
Single color
10% infill Gyroid
0.2mm layer height (I have had success with 0.24mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.42mm widths
Supports advised for underside (bed plate only)
Advised to print laying flat on bed

Dice Box (Sword)
Single color
Slot for (2) round 8x2mm magnets optional
10% infill Gyroid
0.2mm layer height (I have had success with 0.24mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.42mm widths
No supports necessary
Advised to print upright.