Very secure wall bracket for electric guitar (without sound box)

It is a very secure design to support the weight of your guitar:

Possibility to anchor to the wall with 3 screws. Diagonal design for weight distribution towards the wall. Follow the printing indications for greater safety.

Compatible with all guitars with a neck width at the neck joint of less than 45 mm.

NOT SUITABLE FOR SPANISH GUITARS OR ANY OTHER GUITAR WITH A WIDE NECK. NOT RECOMMENDED FOR ACOUSTIC OR ELECTRIC GUITARS WITH SOUNDBOARD.

For other guitar types there are these other models:

• Spanish guitar (with wide neck up to 55mm and acoustic body), also suitable for acoustic guitars (narrow neck): https://cults3d.com/en/3d-model/gadget/soporte-de-pared-para-guitarra-espanola-electrica-acustica-muy-seguro

• Acoustic or electric guitars, narrow neck up to 45mm, with soundboard: https://cults3d.com/en/3d-model/gadget/soporte-de-pared-para-guitarra-electrica-acustica-muy-seguro

Temperature: the maximum recommended by the filament manufacturer. The higher the temperature, the better the adhesion between layers, which in this design is important.

It is printed WITHOUT SUPPORTS and in the direction in which the STL is, with the bottom fully supported on the printing plate (to ensure the best resistance of the arms).

With 0.4mm nozzle, to have optimum resistance, apply at least the following parameters:

• Coating height 0.2mm

• Line width: 0.38mm

• Wall thickness: 2.4mm (6 lines)

• Thickness of top and bottom layer: 2.4mm (12 layers)

• Filling: minimum at 25% (zig-zag pattern works very well and is faster than others).

• Cure] Alternate additional wall: ON (welds the infill more strongly to the walls)

• Without supports