ANET A8 Plus heated bed drag chain holder

Here is my own creation for a drag chain holder for the heating bed.

Unlike the ones published here, the drag chain is mounted horizontally.

This means that no space is wasted next to the bed and the chain is kept stable.

I used a 14 x 17mm 1M Cable Drag Chain R28 nylon cable drag chain here.

The original holes on the bed are used to attach the holder to the print bed,

are used with longer screws.

At the other end of the chain, it is attached to the mounting screws of the control housing

is screwed on.

The chain must be shortened appropriately so that it does not hit the frame.

It is best to push the print bed forward and shorten the chain so that there is a little clearance to the frame, then it will fit.

Here is my own creation for a drag chain bracket for the heating bed.

In contrast to the ones published here, the drag chain is mounted horizontally.

This means that no space is wasted next to the bed and the chain is kept stable.

I used a 14 x 17mm 1M Cable Drag Chain R28 nylon cable drag chain.

To attach the holder to the print bed, the original holes on the bed,

used with longer screws.

At the other end of the chain, it is attached to the control housing using the mounting screws

screwed on.

The chain must be shortened appropriately so that it does not hit the frame.

The best thing to do is to push the print bed forward and shorten the chain so that there is some space left for the frame, then it will fit.