Wall brackets portable support (with tilt)

Wall brackets for wall, to place a laptop. Not suitable for trays with cups, because you can drop them :)

In the download file are these measurements (width 20mm, rib thickness 7mm):

• 225mm usable support capacity x 200mm part height x 20º inclination (239 print height)

• 255mm usable capacity support x 220mm part height x 20º inclination (268 print height)

*If you need a different size or a different inclination, send me a message and I will prepare it for you without any problem, adding it to this same page... EVEN IF YOU HAVE ALREADY BUYED AND DOWNLOADED IT... if it doesn't work for you, give me new measurements and I'll send it to you *.

Note: The big holes that are inclined is so you can put the screwdriver comfortably, ok? ;)

Temperature, retractions and speed... those things, however you know best work for you.

I advise at least 4 perimeter lines and 33% infill. They should print almost solid.

I attach a photo with the position I advise on the printing plate. You can print without supports, except for the little tab on top (I advise tree support, supported only on the printing plate). Put "support removal" in the little holes of the screws, as it is not necessary.

Check that the dimensions do not exceed the capacity of your printer. You can put the piece diagonally on the bed (see photo) so you can print pieces larger than the width of your bed. And check the height, which is also indicated.