Ender 5 Light bar clip

Remixed from Ender 5 Light Mount (https://www.thingiverse.com/thing:3592772) by xqqqqme (https://www.thingiverse.com/xqqqqme) to mount the Ender-5 Light bar (https://www.thingiverse.com/thing:3545616) by derandi3d (https://www.thingiverse.com/derandi3d). You need to print two clips and you also need two M3 flat head screws and M3 nuts. The nuts go in the clip, the screw heads in the light bar. I might add a version 2 of the clip later with nut holes, not cylinder head holes, but it worked for me, so I kept it that way for the moment.

You can see the mount clip on the first two photos and the complete installation including the light bar on the other photos. The last photo shows the web cam photo. On all photos except the first two there was no additional light used except the two LED stripes installed in the light bar. As you can see, plenty of light.

Although derandi3d warned me (https://www.thingiverse.com/thing:3545616/comments/#comment-2811538) about installing the light bar on the top (my problem with "his" installation method was that the print head collided with the LED bar) I am pretty happy with the results, see the photos. But I am sure derandi3d knows what he's talking about so this might not be the 100% solution. But for the moment, it is for me.

If you like the camera, get yourself a PS3 Eye Camera for just some Euros/Dollars (I paid 7 Euros) and take a look at my PS3 Eye Camera Mount for Ender 5 (https://www.thingiverse.com/thing:4056911). The big advantages next to the price are the good results with not much light and also the wide angle mode. I like it very much.

And yes, I know. My prints turned out pretty bad. Filament is wet or some over extrusion.