Tinners Trail organizers

Organizers for Tinners Trail board game. Quick game set up and comfort during the play. Sliding lids prevent components from falling out during the storage. Theme reliefs and cutouts decorate organizers.

The set contains: Resources organizer, Development organizer, Survey card organizer, Area tile organizer, 100Dice organizer, Player's component organizer and Setup organizer.

1. RESOURCES ORGANIZER: It has 5 sections for: tin, copper, water and arsenic cubes, plus drainage tokens. Rounded bottom facilitate item draw. It is an organizer for ~half of resources. 2 such organizers should be 3d printed to accommodate all resources. Containers can be placed on 2 sides of the table, so all players can reach for components easily during the play. Cutouts in the lid are based on picture of Newcomen steam engine from 18th century, Credit: ScienceSource.
2. DEVELOPMENT ORGANIZER: It has 5 sections adjusted to accommodate 5 types of Development markers. Rounded bottom facilitate item draw.
3. SURVEY CARD ORGANIZER: There are 5 slots for: A, B, C, D and * Survey cards. Sloped back and section walls plus indentations facilitate taking decks out. Only cards without sleeves will fit this container.
4. AREA TILE ORGANIZER: There are 4 slots for: A, B, C and D Area tiles. Sloped back wall and indentations facilitate the draw.
5. 100DICE ORGANIZER: In this organizer there are just 2 sections. Ł 100 tokens are accommodated in the first one. Dice and Auction marker are kept in the other. Again, rounded bottom facilitates taking components out.
6. PLAYER'S COMPONENT ORGANIZER: A simple organizer for all components in one color. 5 of them should be 3d printed for all players. There are only 2 sections. One is dedicated for Mines. Other player's components are accommodated in the second section. Nothing special, but during the play you can see how many Mines you have left. I also couldn't make anything larger because of limited space left in the game box.
7. SETUP ORGANIZER: Several types of components that are used in the game set up are kept in this organizer: Area set up cards, Map cards and Emigration tokens.

All organizers fit the game box very well and provide quick game setup. However it's not an insert. Organizers were designed for cards without sleeves.

Some photos in higher resolution:
The set, organizers closed
The set, organizers open
Resources organizers
Development organizers
Packed
Half unpacked

All organizers were 3Dprinted on Prusa MK4 (with Input Shaper):
- in PLA (F3D Gold pearl),
- No support is needed,
- Infill 10-15% gyroid.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK4" in PrusaSlicer.
Note2: Monotonic lines Top fill as default.

Printing Time (for one organizer of each kind) (with Input Shaper):
2h39' - Resources, container
1h51' - Resources, lid
2h47' - Development, container
1h6' - Development, lid
2h41' - Survey cards, container
26' - Survey cards, lid
1h48' - Area tile, container
28' - Area tile, lid
55' - 100Dice, container
30' - 100Dice, lid
53' - Player's component, container
27' - Player's component, lid
1h32' - Setup, container
59' - Setup, lid