Hookah body Chernobyl Chimney

!!!PLEASE READ THE ENTIRE DESCRIPTION TO AVOID PROBLEMS!!!

For fans of the S.T.A.L.K.E.R game series or the Chernobyl series, I created a hookah body in the shape of the Chernobyl chimney.

The hookah body has a base so that it doesn´t interfere with the hoses.I made the interweaving from a thin rubber band. Since I worked on it for several days and wanted to have it for New Year's Eve, the model was not painted yet.

Model information:
- Height: 203mm
- Inner diameter of the hole: 16.7 mm
- Max outer diameter: 73.4 mm
- Diameter of the hole on small floor: 2.95mm
- Diameter of the hole on the middle floor: 3.3 mm
- Diameter of the hole on the largest floor: 4.4 mm

Warning!!! It should be borne in mind that the 3D printer doesn´t print exactly, i.e. the inner diameter was made for a rod with a diameter of 16 mm and the body fit exactly

♥Good luck with printing and I hope the model gives you as much joy as it does me♥

Printed on: Elegoo Neptune 4
I used the Preset Profile: Fine (0.12mm)

• Layer Height: 0.12
• Printing temperature: 220 ºC
• Printing speed: 250 mm/s !Risky but i need it fast :D

Support
-Support Placement: Everywhere
-Support Overhang Angle: 60°
-Support Pattern: Zig Zag *Hard to clean model *
-Support Density: 13%
-Support Brim Width: 8.0
-Support Z Distance´: 0.1
-Support Interface: Roof and Floor
-Towers: Yes

You have to be careful if the printer is properly calibrated so that it doesn't bump into higher floors.When I moved the printer to another place, I had to calibrate it again because I had exactly this problem.