One of my favorite albums from Bright Eyes! Hope you enjoy!
If you only have one AMS leave the last filament empty so that it pauses when it gets to it. Then switch all the rolls needed. This is how I do mine.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic BambuLab Green Transmission Distance: 8
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Beige Transmission Distance: 8
PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #15 (1.28mm) swap to BambuLab Green
At layer #17 (1.44mm) swap to Red
At layer #19 (1.6mm) swap to Yellow
At layer #20 (1.68mm) swap to Beige
At layer #21 (1.76mm) swap to Jade White for the rest.