Whistle missile keychain
Whistle missile keychain
Boost
46
62
21
GIF
Print Profile(1)
0.2mm layer, 2 walls, 35% infill
Designer
56 min
1 plate
Boost
46
62
21
0
106
80
Released
Description
WHISTLE MISSILE KEYCHAIN
MEGA STRONG WHISTLE IN THE SHAPE OF A MISSILE AND WITH THE POSSIBILITY OF USING IT AS A KEYCHAIN.
MULTICOLOR (NO AMS REQUIRED) WITHOUT PRIMER TOWER (OK TESTED)
PRINT IT OUT, DON'T WASTE TIME…
ENJOY AND LET ME KNOW WHAT YOU THINK IN THE COMMENTS, THX!!!
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 35% infill
Very loud, does the job.
The designer has replied
1
Reply
thx👍🏻
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
très bien
The designer has replied
1
Reply
THX ❤️
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
good sound
The designer has replied
1
Reply
thx
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
not sure if the filament tri color I used caused it but it got stringy at the end then it fell into the floor and snap in two at the bottom. loud whistle though I was hoping it was more like those little footballs from back in the day so I could strap it to my racing drone.
The designer has replied
1
Reply
I can confirm that the problem is the filament... I tested it and it is very rigid. try printing it with a good filament. Thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
printed well, not that loud
The designer has replied
1
Reply
strangely it also exceeds 125db, it even reached 129db (a matter of breath perhaps)
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
I love this thing in my Keys
1
Reply
If you try to print more than 1 and it fails near the top every time. Extruder knocks them all over. Still usable just not a completed model. Done it 3 times now all fail at the same point. Don't think I'll waste any more filament.
The designer has replied
0
Reply
add the brim. and check your first layer if it's great (cleanliness, offset, and if it's pressed well on the plate). However, add the brim and you're safe
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
The designer has replied
1
Reply
thx 👍🏻
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
The designer has replied
1
Reply
THX
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
The designer has replied
1
Reply
THX
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld