Strapon Magnet
Copyright Claim
Strapon Magnet
Boost
26
38
18
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
35 min
1 plate
10 inch wide 12x3 magnet 0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
Boost
26
38
18
0
60
71
Released
Description
Fun little magnet I made for my toolbox. Since I do not have a true snap-on tool box, I made this to slap on the side.
Magnets used:
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
😶👌🏿👌🏿🙏🏿
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
purple looks sick!
0
Reply
I used 6x3 magnets. I had to glue the magnets in because the holes weren't snug. the 6x3 magnet will work but will stick out the back 1mm.
The designer has replied
1
Reply
I use 6x2 magnets and made it so it needs a dab of super glue in it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed nice shaping it on a couple coworkers boxes
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Made one for every tech at work! Also made one for my Matco guy!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome ! thanks for sharing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
10 inch wide 12x3 magnet 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld