BentoBox V2.0 - Thermo Top
Remixed by
Copyright Claim
BentoBox V2.0 - Thermo Top
Remixed by
Boost
4
14
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
44 min
1 plate
Boost
4
14
8
0
15
8
Released
Description
A BentoBox V2.0 cover that can house a KSD301 thermo switch. This was inspired by @quietsnow's version.
The switch is a compression fit and should sit snuggly in place. There's a hole to one side of the cover in order to accomodate the wiring. The fit and magnet sizes are the same as the original BentoBox V2.0 - it should be a simple swap.
The profile included is a generic Bambu PETG profile - however, I printed mine in ASA. I wouldn't recommend PLA.
The STEP is included should anyone wish to make adjustments.
Comment & Rating (8)
All
Going to print this. How did you connect the cables? Both fans parallel and the red plus to the temperature switch and then to the printer PSU of the Bambu?
The designer has replied
0
Reply
yeah, both fans live to switch then to live on the psu, and the grounds direct to psu.
1
Reply
Also, I have the 40c switch which turns on at around 34 and off at about 30. so keep in mind those switches aren’t exactly accurate to whatever the Bambu chamber temp reads :)
1
Reply
Replying to @cadr
Thank you very much. I ordered a 30 degree and 35 degree sensor, but they don’t cost that much and maybe 40 or 45 will be better - I will see. I just printed almost 2kg ABS in the last days and the printer is so dirty, have to make the Bentobox work soon…
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked really well
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print. Looking forward to bring everything together.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld