Kunai - House of Ninjas
Copyright Claim
Kunai - House of Ninjas
Boost
26
37
14
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
1.2 h
2 plates
Boost
26
37
14
0
69
65
Released
Description
Kunai - House of Ninjas
The creation of this kunai was the first creative image that came to my mind when I was watching House of Ninjas, so I designed it.
The assembly is quite simple, but it requires glue. First, fix the two locating pins on one of the kunai, and then apply glue.
Comment & Rating (14)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
Nice model!
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Came out pretty good and sharp. Just have to superglue the pieces together.
0
Reply
Great Kunai. Awesome work/design.
I think due to my print bed size I had to upscale it by 120% to make it more real life size (11 inches).
I paused episode 7 and compared hand size to the Kunai. Hehe
I used 100% infill. Looks great, feels hefty and solid.
I printed without calibrating the pla.
Will sand it and post another pic.
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
👍
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Awesome file and the print is fantastic
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
the assembly was a little hard but overall okay
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Strength Issue:Ends of the blades are rather thin and bent easily which caused the two halfs start to split.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld