This is part of my series of adventurous pug themed coasters, created with HueForge. This is designed at 4.07mm thickness and 100mm (4-in) square, but can be scaled up to make it into wall art. Just make sure to uncheck the uniform scale box, and do not scale the z axis at all. Due to the thickness, make sure you have really good adhesion, and turn off the aux fan to minimize the chance of warping.

Print settings:

• 0.16mm base layer
• 0.08mm layer height
• Ironing all top surfaces (25% flow)
• 25% gyroid infill
• 9 top shell layers and 0.8mm top shell thickness
• 5mm brim with 0.02mm gap

Filaments and color changes (TD values are my own and may not match HueForge defaults)

• Started with Overture matte navy blue (TD 0.3mm)
• At layer #30 (2.48mm) swap to Overture matte red (TD 2.4)
• At layer #34 (2.8mm) swap to Overture matte orange (TD 3.2)
• At layer #37 (3.04mm) swap to Overture matte yellow (TD 3.6)
• At layer #43 (3.52mm) swap to Overture matte white (TD 4.0)

The included print profile includes the pauses. If you're using an AMS, edit the pauses to be filament changes, and you'll need to add the 5th color (white) to slot #1 at some point after layer 30.