I've been wanting an easy/quick print Pokeball for a while and wasn't satisfied with anything on Thingiverse. They were all either too complicated or didn't look good. TheDesignerd's spinner had good looking Pokeballs with a simple design. I just took his model and changed it so that it was just the Pokeball, without all the spinner parts.

The button is unchanged. The center piece is really just simplified, it is now just a simple cylinder basically. The hemisphere is cut to allow the center to fit in.

The pokeballs on his spinner look much nicer than the one I printed, so look at his for a better picture. The proportions are the same so this should like just like his when printed.

I estimated the size of this, it is about 40mmx40mmx45mm. Print at 2x size for a more realistic Pokeball

The hemispheres print in about 15 minutes each(print 2, one white, one red). -no supports needed but do it if your printer can't bridge well.

The center takes about 15 minutes as well.

The button takes around 2 minutes.

Print Settings

Rafts:

No

Supports:

Notes:

I had to print the button a bit smaller to get it to fit.

Also, TheDesignerd suggested supports on the hemisphere for his model but I printed it fine without them as long as it is oriented like an igloo.