𝐔𝐏𝐃: I am currently working on a version that uses 𝐚𝐜𝐭𝐢𝐯𝐚𝐭𝐞𝐝 𝐜𝐚𝐫𝐛𝐨𝐧 𝐩𝐞𝐥𝐥𝐞𝐭𝐬 to reduce the toxins of the solder fumes which I will release 𝐒𝐎𝐎𝐍!

I solder a lot on my Proxxon FMZ so I decided to create a simple fume extractor that attaches on the back of the vice that uses a 4040 fan. You might need to use a dab of hot glue to secure it on the vice

𝐍𝐨𝐭𝐢𝐜𝐞: The Fume Extractor can be mounted in 2 positions, 90 degrees from the vice (vertically) or slightly angled upwards, like you can see in the photo. If you want to mount it slighly angled you will have to clip the square edges at a 45 degree angle (about 2-3 mm not more)

Print Settings:

Layer Height: 0.25
Infill: 25%
Supports: YES
Orientation: Horizontal
Material: Any