Primary I designed this Hexagon tile set to hide my cables from the TV. So there is plenty of space for cable management behind the tiles. There are four eyelets on each base plate for using zipties.
Since the Tiles are featureing magnets to snap onto the base plate, they can easyly be removed or replaced for further upgrades and changes.
Update 24.02.2024
Added Half and Quater Tiles including Base in various heights
Update 10.03.2024
Add 15mm Tile for an "ESP32-2432S028R" - display (CYD)
The general Tile size is 175 x 202mm
The heights can go from 20mm up to 55mm in 5mm increments depending on the choosen base plate and tile size.
Parts:
Before you start this project you should make a Sketch how you want the tiles to be orientated on the Wall. The file of the "Base Plates" consists of 7 individual parts where 6 of them can be removed individually for defining how the cables should run and how the base plates are connected to each other.
If you miss this step and print the base plate without removing the connection sides, you have no openings for the bow ties to connect each tile to another and alighning them will be much more difficult.
Using Bambu Studio for customization:
Right Click on the base plate > split > to parts |
Switch to the “Object” Tab and remove the unwanted parts |
The LED Tiles can also be splitted apart for easy coloring.
For best looking Result the tiles should be printed on a textured PEI - plate.
The hole for the magnet is a tight fit, I used a hammer and a pin to put them into place. On the Cover plates be more careful when using the hammer. |
The bowties can pressfit into place |
Screw the Base Plates into the wall |
Install the LED stripes into the LED Tiles |
Install the Tiles and do the cable management |
Have Fun! |