Assembly instructions:
clip the leg to the stand, no glue needed.
Recommended filament: PLA
Hotend: 0,40mm
Print time: 0:39h
assembly time: 1 minute
Print instructions:
Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.
Bad build plate adhesion is not related to the model.
Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!