--------------------------------------------------------------------------------------------------------------------------------
A straightforward filament clip to reliably secure your filament!
I've tried numerous filament clips before, but none quite met my expectations.
Thus, from this requirement, I've conceived this petite clip!
Swift and easy to print, it prevents filament tangling for ALL spools! it will work for both 1.75mm and 2.85mm diameter filaments.
The filament grip, unlike all other clips I've tried, isn't ensured by a specific geometric shape carved inside the profile but rather by the angle between the wire and the entry section into the clip. I have personally tested this model on all my BambuLab spools.
Just 2 gram of filament are required for this print🔥
this is mine V1 model, so, if you have any suggestions for make it more efficient I’ll try to improve them, just pm me🙏❣️