MAGNET/MAGNET EYE (AMS/MULTICOLOR)

ATTENTION!

BEFORE PURCHASING THE DESIGN, THIS IS A .STEP MODEL DESIGNED TO BE PRINTED ON A PRINTER WITH MULTICOLOR SYSTEM SUCH AS AMS OR AMS LITE. IT IS NOT VALID FOR A CONVENTIONAL PRINTER

Magnet with eye. I include 4 versions:

3 versions with tolerances of 0.1, 0.2 and 0.3 mm for use with this magnet. I have used these magnets. In size 10x2mm

https://a.aliexpress.com/_EuNE54t

Flat version to stick any magnet on the back (stick it with loctite).

I include the 3mf file with all pre-painted versions in different printing plates, just choose the one you want and send it to print. The printing time for 1 magnet is about 45 minutes only.

////////////////////////////////////////////////////////////////////

ATTENTION!

BEFORE YOU PURCHASE THE DESIGN, THIS IS A .STEP MODEL INTENDED TO BE PRINTED ON A PRINTER WITH A MULTICOLOR SYSTEM LIKE AMS OR AMS LITE. NOT VALID FOR A CONVENTIONAL PRINTER

Magnet with an eye. I include 4 versions:

3 versions with tolerances of 0.1, 0.2 and 0.3mm to use with this magnet. I have used these magnets. In size 10x2mm

https://a.aliexpress.com/_EuNE54t

Flat version to stick any magnet on the back (glue it with loctite)

I include the 3mf file with all the versions prepainted on different printing plates, you simply have to choose the one you want and send it to print. Print duration of 1 magnet is around 45min only

1 wall

0.2 mm layer height

0.28 mm initial layer height

3 lower layers

3 upper layers