Dart board LED Light
Copyright Claim
Dart board LED Light
Boost
39
44
20
Print Profile(4)
PLA 0.2mm layer, 2 walls, 15% infill
Designer
3.6 h
1 plate
PLA 0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
ABS 0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
ABS 0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
1 plate
Boost
39
44
20
2
110
118
Released
Description
A simple darts LED ringlight.
It fits a standard size board (45cm) and has a max diameter of 60cm.
The slot for the LEDs has a width of 11mm, which fits most standard LED stips (8mm or 10mm).
Simply mount the LEDs with the applied adhesive.
No glue or additional parts are needed to assemble the whole ring. Simply snap the connectors to the four stands.
For me it worked perfectly without any need for additonal glue or adjustment to the parts.
You can install the Ringlight to backboard using simple Wood screws.
I hope you enjoy it.
Comment & Rating (20)
All
Love this Dartboard light! Any chance of a remake with brackets that support a dartboard surround? this is by far the best dartboard light, but I miss using the surround.
The designer has replied
1
Reply
With sorround support you mean making the stands more compact and getting them closer to the board to fit a surround around them?
0
Reply
yep exactly. Although, I mounted this to the surround directly last night and it worked great, so I wouldn't worry about modifying it. I only used one screw per leg as well, this print is so light it held in the foam great. LOVE this one mate 👍 Gonna reprint in red to match my surround.
(Edited)
0
Reply
Great model, printed perfectly and looks amazing, thanks!!
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
Perfekt! Danke!
1
Reply
is it better to mount to the wall or to the board?
The designer has replied
0
Reply
This model is meant to be mounted to the wall. There are no holes or similar to mount it to the board
0
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
Ein tolles Probent und gut umgesetzt. Ich den Ring nur etwas zu klein. Ich hätte gerne einen mit 73 aussendurchmesser.
Beste Grüße
1
Reply
such a great idea!
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
PLA 0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld