This is a minimalistic phone holder for Peugeot 1007 and other vehicles with the “ball vents." You can glue magnets to it or glue it to a phone cover and use as is or remix it to hold a specific phone.

This holder allows for tilting your phone using vent itself. It is easy to put on and off the vent.

Also you can use two of them to hold a tablet in the middle of your dashboard. Use included spacer to get the exact placement of both parts. Spacer is not supposed to be glued on your device. Use it only as a template.

There are two versions. Slim and Easy to print.

Slim should be printed upside down with supports from build plate only.

"Easy to print" can be printed laying on the flat side without supports but is thicker.

You can also check out my vent cover for Peugeot 1007 here: https://makerworld.com/en/models/208898