Helmet Holder Support
Copyright Claim
Helmet Holder Support
Boost
29
47
4
Print Profile(1)
0.2mm layer, 2 walls, 7% infill
Designer
7.8 h
1 plate
Boost
29
47
4
0
88
29
Released
Description
Hi!
I needed some helmet holders so i desgned them like machined part.
No support required. Infill 7% except under the srews, where the infill is 80%.
A very strong version, no doubt that it can support a big helmet!
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 7% infill
Tip Top 👍🏼
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 7% infill
(Edited)
0
Reply
No more
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld