1st things 1st:

Leave a like if you download AND tips to improve the design are highly welcome.

As i could not find a proper Stand for the EE-3 Blaster, i decided to give my little knowledge about 3D modeling a chance and put together this little Blaster stand in Blender.

This Stand is about 13 cm´s (or 5,11 inch) tall, so the stock part will be lifted high enough to not touch your shelf, desk or wherever it might stand - IF the Blaster is balanced well enough... mine is not... too much weight on the stock.

Base will fit to print on an Ender 3 V2

I also wanted to have the Stand as short as possible so i decided to have only 1 Holder in the Middle of the Blaster. It will sit directly under the Fire Chamber, fitting RKORMOS Blaster (https://www.thingiverse.com/thing:1025804), or April Storms Original
http://www.thingiverse.com/thing:150686.

Additional thanks to Farshadnia and ty10y for creating the Mandalorian Symbols i used.

Printing Tips:

Print the Holder upside down.
I used Cura and put 2 Blockers on the thinner Parts with 100% infill.
Or you just go and print the whole thing with 100 % infill, just to make sure its solid enough to take the weight of the blaster.

Use 2 screws to connect Base and Holder (obviously...)

Happy printing