This is meant so that you can wish utensils with a thin stem such as Chopsticks, Spoons, Forks, etc in the dishwasher basket without them falling through.

IMPORTANT: The models are solid. In order for this to come out in the photos you need to slice it specially.

This is designed for a GE Dishwasher Basket. I'm not sure how standard/generic these baskets are (or not)

Set Top and Bottom Layers to Zero

Set Infill to your choice - I used Honeycomb - and set to your desired density. In these pictures I believe I used 15%

Print in the highest temperature filament you have. PLA is a no go, will immediately melt/warp first cycle. PETG survives for a few months, so I just reprint every few months.

Recommend Scaling up in Z for a thicker strainer, if using PETG (It helps it to not warp as soon). Try 3-5mm.