Inspired by Fabernex's "Kickstand for Samsung Galaxy Tab S9 Ultra", I completely remade it for the Samsung Galaxy Tab S9 FE. You'll need to print of the both the right and left hinge and the kickstand. If the kickstand can't fit on your printer bed I have provided and two piece kickstand. I did manage to fit the full size one on my 220x220 bed by printing it on an angle.

What you'll Need

• Right Hinge Print
• Left Hinge Print
• Kickstand Full Print
• M2 20mm (4)
• M2 Nut (4)
• 10x2 Magnet (8)

If you're printing the two piece kickstand

• Kickstand Right
• Kickstand Left
• M2 15mm
• M2 Nut

Assembly

1. Take your magnets and place them direct on the back of your tablet. Take a marker and mark the top of the magnets. Polarity is important. Place the magnets on the hinge pieces exactly the same spots as they were on your tablet with marker side up. It is important the magnets don't get mixed up otherwise the hinges will not attach to the back of the tablet. I used super glue to attach the magnets to the hinge pieces. You can probably tape over the magnets as well.
2. Attached the the hinges to the kickstand piece. Make sure the screw holes line up. The fit will be tight. You may have to shave it down a bit if you have elephant footing or it's too tight. Thread the screws through the holes. Everything must be tight if you want the kickstand to work correctly.
3. Attach the the kickstand to the back of your tablet. It should magnetically attach with no issue. You may want to adjust the tightness to your preference.

If you're using the two piece hinge all you need to do is attach the two pieces and thread a screw through the holes. I countersunk the holes so that screw head and nut won't cause issues.

Please sure your makes! If you have an issues shoot me a message and I'll try my best to work out a solution for you.