NZXT cases have a unique and clean look. But most of them, including the H210, have bad airflow with the stock front panel.

This model solves this issue and will make your PC breathe a ton of fresh air !

It fit perfectly on the case just like the original one.

Things needed

• 4 10x2 round magnets
• Glue (can be any type from super glue to hot glue)

Print

None of the pieces require supports, I recommend printing them in 0.2mm layer height for the parts to fit nicely.

To put custom text like I did on mine, you can do it directly in Bambu Studio on the right bottom part.

Make sure your bed is well leveled to ensure a smooth surface.

Assembly

Simply insert the connectors in one of the two panels and assemble it with the other one, then you can glue everything together (optional)

Note : don't use black hot glue like I did on my first try if you print this model in white.

Then glue the magnets on the four standoffs.

Finally, remove the old panel and replace it with this one, don't forget to post a make and to tell me if you encounter any problems !