Model

Do NOT adjust the size in your slicer!! The layers will not come out right.

Do not change the size, this will cause errors in color change compromising the entire print.
Use my print profile or you will not get the desired results.
It can be printed safely without AMS and on any printer.
I hope you like it, I hope you like it, if you want to support me leave a like and vote five stars thank you!

Nozzle: 0.4

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Matte Mandarin Orange Transmission Distance: 3
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Charcoal
At layer #7 (0.64mm) swap to Jade White
At layer #13 (1.12mm) swap to Gray
At layer #14 (1.2mm) swap to Jade White
At layer #16 (1.36mm) swap to Charcoal
At layer #19 (1.6mm) swap to Mandarin Orange
At layer #22 (1.84mm) swap to Jade White for the rest.