Hi, everyone, this spool holder is vert strong, I have already use it for three years.

You may print it with petg/abs or even pla!

Compare to other designs, it doesn't need any screws, but just two 608zz bearings

Print setting

• raft: no
• support: some of them need
• resolution: 0.2
• infill: abs 20%/petg 40%/pla 80%
• wall: abs 3/petg 4/pla 5
• notes: remember to print two base, you wil know how to install once you have print it out.

Container

• recommended size: 23 x 14 x 26 (xyz cm)

Needed materials

• 2x 608zz bearings
• printing parts

Thank you