Monitor-like iPad/Tablet Stand by Mihai

Mihai

Household>Office

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

3.4 h

1 plate

5.0(2)

Boost

Released

Description

UPDATE 1: Widened the stand stem to reduce wobbliness and thickened the connector for a more tight fit, all based on received feedback. Any further feedbak is very welcomed!

UPDATE 2: Adjusted connector pin tolerances!

No supports needed to print this model! No tools needed for assembly!

iPad/Tablet stand that can be used alongside a computer monitor, or by itself! I made this to use my ipad in external monitor mode with my mac mini.

This model allows for all kinds of tablets to be used, though i only tested it with a 12.9 inch and 9.7 inch ipad pros and allows passthrough of the charging cable at the bottom.

Since i made this model to be as compatible as possible with as many tablets as possible, the stand allows for 9mm thick tablets (or tablets with thinner covers installed) and features a v slot at the bottom to make swipe up gestures and home button presses easier.

The stand is slightly tilted backwards and the tilt is fixed.

Recommended infill: 20%-30% or more (more infill, more stability and durability).

Note: This is my first ever model to be published anywhere on the internet! I'm not an expert in cad modelling, but this is the best model i have ever made! I would love to hear some feedback!

Comment & Rating (6)

@fellner10

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice👍🏻👍🏻👍🏻

@GuitarBoii94

It looks really sleek and clean. It looks great next to my pc monitor. my only complaint is that it is a little wobbly. I superglued everything together and it still feels a little wobbly. I’ll try a print with petg and see if helps to be more rigid.

The designer has replied

@user_1901512613

Thank you for the feedback! I will update the model with a wider stem to reduce wobbliness.

@fangel83

Great model! Good print. Only the pin is a little loose at the side of the tablet holder.

The designer has replied

@user_1901512613

Thanks for your feedback! I didn't realise it at the time, but i had a little bit of an elephant's foot on the pin and it fitted tight because of it. i will update the model to make the fit better.