Magnet pusher

Copyright Claim

Magnet pusher

Boost
12
26
1

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 20% infill
0.2mm layer, 3 walls, 20% infill
Designer
43 min
1 plate
5.0(1)

Boost
12
26
1
1
19
10
Released

Description

Because i have sore hands most of the time and some BS going on with my hands i alway struggle to do small stuff with my hands. So i came up with this solution to put magnets in. No more screaming to magnets and my hands. I really love them. I placed a 6x3 magnet in. MAke one blue and make one red for positive and negative side and your good to go. Also works if the magnet is to snug just give it a tap with a hammer that's why i added the thick back.

 

You can sell our designs we made and are available on our makerworld page. Wit a small sub on our Patreon you get a commercial license to sell and back our non profit founding for Children with special needs: https://www.patreon.com/wickieprints/posts

Comment & Rating (1)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 20% infill
Printed great. I was looking for something simple to install magnets and found this before I drew something myself. Thanks!
0
Reply
No more